If mounting your AP to a dropped ceiling, skip to the "Getting Power to the AP " section. The mount cradle can then be held with one hand while the other hand holds a screwdriver. Tip: Pre-assemble rubber spacers and screws to the mount cradle. Attach the mount cradle to the T-rail clips using the mount cradle holes (marked with a “T“).Tighten the set screws on the T-rail clips to secure the clips using a 5/64”(2 mm) hex key.Using the dashed lines on the mount cradle template as a guide, set the proper spacing of the T-rail clips on the T-rail.The black foam pads should be compressed slightly after installation. Attach the T-rail clips to the T-rail by rotating them and snapping them into place as shown.The kit contains:ĭrop ceiling mounting clips with set screwsĦ-32x7 mm screws only used for recessed rail mount The accessory kit can be used to mount to most 9/16”, 15/16” or 1 ½” T-rails. To mount your AP on a drop ceiling T-rail, use the included drop ceiling mounting accessory kit. If necessary, reconnect the AP to the LAN.Configure the static IP address, net mask, gateway IP address and DNS servers that this AP will use on its wired connection.Qxxx-xxxx-xxxx), with no password (e.g., Q2DD-551C-ZYW3). The default login is the serial number (e.g. Click on the “Uplink Configuration” tab.Using a web browser on the client machine, access the AP’s built-in web server by browsing to.If using a PoE Injector, connect the AP to the “PoE” port of the Injector, and the client machine to the “LAN” port. Then connect the client machine over Ethernet cable to the PoE switch. If using a PoE switch, plug an Ethernet cable into the AP’s Ethernet jack, and the other end into a PoE switch. If using a wired connection, connect the client machine to the AP either through a PoE switch or a PoE Injector.Using a client machine (e.g., a laptop), connect to the AP wirelessly (by associating to any SSID broadcast by the AP) or over a wired connection.The following procedure describes how to set the static IP: Static IPs are assigned using the local web server on each AP.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |